Manufacturer: Reci
Brand: Reci
Power supply DY10 for w2/z2/s2 CO2 Laser Tube Reci  High Quality and Extra Long Life. FEATURE: DY13, The product is featured as small size, quick response, which is suitable for Reci W4/z4 laser tube. Item  RECI-DY10 Input Input Voltage AC220V or AC110V (The order should be especially instructions )  AC Frequency 47 - 440Hz  Max Input Power 550W  Max Input current 8A Output Max output Voltage 40KV  Max Output current 28mA Efficiency equal or more than 90%25 ( load down ) Time no-failure equal or more than10000h Response speed equal or less than 1mS (the time from output of switch signal to 90%25 of initial setting current ) Voltage - resisting Input - Output ,input - machine hull: C1500V 10mA 60s; output cathode and machine hull connection Usage environment Work temperature (-10 ~ 40) , Relative humidity: Equal or less than 90%25 Cooling Type The compulsive air cooling  I. Instruction for sub - connection wire of the control end: Footer 1 is 5V power supply. (Not needed when connecting the cardinal plate. It is used when regulating the power with potentiometer and the 5V current should be less than 10 mA. TH. TL refers to high and low power level respectively, and WP refers to water protection. Footer 5 G refers to ground and 6 refers to input end. When connecting the control plate, connect the light signal with footer 2 in the case of high power level light-emitting, (footer 3 for low power level light-emitting), connect the ground-wire with footer 5, connect footer 6 with power control analog signal, and make short circuit for footer 4 and 5. PWM can also be used in footer 6, but the pulse peak is required to reach 5V, and the frequency should be above 20K. For testing: 3, 4 and 5 are in short circuit (or 4, 5 are in short circuit and 3, 5 are connected to switch), the potentiometer center is connected with 6 IN, and the two other ends are connected to 5V and ground (1 and 5) respectively. The high power level controls the light, 1 and 2 are connected,