Surecall Full Band Short Yagi Directional Antenna

Manufacturer: maxmostcom Brand: maxmostcom Model: C0-J81Z-YCCD

Yagi antenna is ideally suited for providing and/or improving reception in residential homes, work shops, small-sized parking garages, basements , small office areas, rural areas and places where the reception is weak. It will help to boost signal and increase data transfer speed. The package contains Wide-Band Log Periodic Yagi Antenna with 30ft cable, mounting hardware and Antenna adapter for Huawei E5775 E8278 E5786 E5786s E3272 Modem 700MHz-2700MHz Wide-Band Log Periodic Yagi Antenna * Frequency Range (MHz): 698-960/1710-2700 mHz * Gain: 11 dBi * VSWR: =21 * Max, power(W): 50 * Connector Type on Antenna: FME male * Lightning Protection: DC ground * Antenna Dimension (mm): 445x210x70 * Rated Wind Velocity(km/h): 100 * Radome material: protected ABS * Cable on Antenna (mm): 400 * Diameter of installation pole(mm): 30~53 * Working Temperature(C): -40~+60 * Extension Cable with LMR200 * Extension Cable length: 30 ft * Extension Cable connector: FME Female Huawei E5775 E8278 E5786 E3272 Antenna Adapter * Connector: FME Male * Cable: RG174 * Length : 17 inch * Impedance: 50 ohms The wide Band Log Periodic Directional Antenna will collect the cell tower signal and send it through the cable to an amplifier, cell phone or cellular data card. When the cell phone or cellular data card transmits, the signal is transferred to an amplifier or directly to the antenna and broadcast back to the cell tower.

Manufacturer: Wilson Electronics Brand: Wilson Electronics Model: 813986009291

Description:The Wilson 304475 Multi-Band Yagi Antenna is a 700MHz - 2500MHz antenna with 8-10 dB of gain. As a dual band antenna it's ideally suited for use with one of our dual band amplifiers, like the 65dB Wilson DB PRO. The higher gain of this directional antenna would greatly improve the performance of these amplifiers compared to other antennas. The sealed housing is UV stabilized ABS plastic and is fully weather-proof.

Manufacturer: Wireless Extenders Brand: Wireless Extenders Model: YX050 Color: Neutral

The YX050-PCS-CEL antenna provides enhanced signal strength in all directions (omni-directional) from this ceiling mount antenna. The antenna should be located near the center of the area where improved signal strength is desired. The antenna may be connected directly to the Base Unit or located near the Base unit using the supplied 10’ RG-8x extension coax.The use of radio distribution equipment that enhances, extends or amplifies a wireless signal may be prohibited without the consent of the wireless carrier upon whose network such equipment will be used. You should consult with your carrier before purchasing such equipment to use with that carrier’s service.

Manufacturer: WANZHOU Brand: SIGNALBOX Color: 70dBi AT&T 4G 700mhz

Introduction: This signal amplifier is 70dB and suitable for home or small building use. It improves cell phone voice and data reception, adding bars of signal to your phone and increased data transfer speeds. It also helps prevent dropped calls. It doesn't require a direct connection to your phone, but rather works wirelessly. It can also work for multiple users at the same time. This amplifier is AT&T 700MHz single band, meaning that it only works with the AT&T 700MHz network. Features: 1.Small Size, Light Weight, Beautiful Repeater 2.Low Operating Temperature 3.Low Power Consumption 4.CE and FCC ID Certification Accepted. FCC ID: YYO-PTEL70A Guarantee: 1.30 Days Customer Satisfaction 2.3 Months Free Replacement 3.2 Years Manufacturer Warranty 4.Fast Handle time & Free Shipping 5.Support Wholesales, More Units More Discount Package Includes: 1.1 x 70dB AT&T 700MHz Booster 2.1 x 12dBi Gain Outdoor Yagi Antenna with 10 Meters Cable 3.1 x 7dBi Indoor Omni Whip Antenna 4.1 x Power Adapter 5.4 x Velcro for Mounting 6.1 x English User Manual

Manufacturer: maxmostcom Brand: maxmostcom

This is a discreet high quality omni-directional MIMO antenna,designed for sending and receiving 2G,3G and 4G signals . Typical applications include strengthening communication and increasing the data transfer speed in the 3G and 4G band. The package contains 1 wide band MIMO Antenna with 2 x 30ft cable, mounting hardware and 2 Antenna adapter cables for NETGEAR Zing AirCard 771S AC771S AC771 3G 4G LTE Hotspot 700MHz-2700MHz MIMO Antenna * Frequency Range (MHz): 698-960/1710-2700 mHz * Input Impedance (Ω) 50 * Gain(dBi) dB 4/7 * VSWR:

Manufacturer: TDMAX Brand: TDicall Model: CDMA/PCS Color: Yellow

Spectrum: 824-849MHz (Uplink), 869-894MHz (Downlink) / 1850-1910MHz (Uplink), 1930-1990MHz (Downlink) Booster Max. Output Power: 27dBm Booster Max. Gain: 65dB Booster Port: N Female Impedance: 50 ohms Input: AC 100V - 240V, 50Hz - 60Hz Output: DC 9V Working Temperature: -15℃～55℃ Outdoor Log Periodic Antenna Gain: Max. 9dBi Indoor Panel Antenna Gain: Max. 8dBi Package includes: 1x 850/1900MHz Signal Booster w/ power supply 1x Outdoor Directional Log Periodic Antenna 1x Indoor Directional Panel Antenna 1x Quality 10m 50Ω Low Loss Cable 1x Quality 5m 50Ω Low Loss Cable Installation Guide: 1.Check and find a place where your cell phone can receive the best signal outside your house, usually on the roof, or similiar high places, then fix the outdoor antenna there, and the outdoor antenna should be pointing to the cell tower's direction. (The outdoor antenna should not be higher than the lightning rod on top of the building.) 2.Fix the repeater device somewhere inside the house, the repeater should be fixed in a place where is near from the power socket, and have good ventilation.3. Runs the cable for the outdoor antenna into the house, and connect the cable connector on the OUTDOOR port of the repeater tightly.4.Tightly connect the indoor panel antenna and the INDOOR port of the repeater by the cable connectors.5.Turn on the power of the repeater. Attention: The distance between the outdoor and indoor antenna should be above 7 or 8 meters....

Manufacturer: Phonetone Ltd.

Introduction: The booster kit includes an booster, an indoor antenna and an outdoor antenna, the outdoor antenna can pick up good mobile signal from outside of your house, and send the signal through coaxial cable to the booster, the booster can amplify the signal, then the amplified signal is sent to the indoor antenna, the indoor antenna can transmit the signal into your house, so you can enjoy clearer phone call or faster mobile date inside your house. Guarantee: 1. 30 Days Customer Satisfaction 2. Three Months Free Replacement 3. 3 Years Manufacturer Warranty 4. FCC authentication certificated,FCC ID: YYO-PTEA70 Package: 1. 1 * Booster 2. 1 * Power Adapter 3. 1 * Mounting Screw Kit 4. 1 * English User Manual 5. 1 * Indoor Antenna 6. 1 * Outdoor Antenna Preparing to Buy a Booster: 1. Check your frequency, because different Phone Providers operate on different frequencies. Usually, 850MHz and 1900MHz are associated with voice and 3G data; while 700MHz and 1700MHz are associated with 4G data. For more detail, refer to wirelessadvisor.com. 2. Make sure that you can make calls outside your house, at roof or wherever you plan to install the Outdoor Antenna. If there is no signal outside your house, the booster will not work for you.

Manufacturer: maxmostcom Brand: maxmostcom

This is a discreet high quality omni-directional MIMO antenna,designed for sending and receiving 2G,3G and 4G signals . Typical applications include strengthening communication and increasing the data transfer speed in the 3G and 4G band. The package contains 1 wide band MIMO Antenna with 2 x 30ft cable which has SMA Male connector for Novatel SA 2100 SA2100 w/ Embedded Verizon 3G/4G Modem and mounting hardware 700MHz-2700MHz MIMO Antenna * Frequency Range (MHz): 698-960/1710-2700 MHz * Input Impedance (Ω) 50 * Gain(dBi) dB 4/7 * VSWR:

Manufacturer: Wilson Electronics Brand: Wilson Electronics Model: 460109

Developed specifically for M2M installations, the Wilson Electronics Signal 3G is based on the same field-tested, market-proven technology that powers Wilson's cellular signal boosters for the consumer market. The Signal 3G is ready to integrate with cellular modems to provide reliable signal that ensures successful data transfer. This booster kit works with all North American wireless service provider networks. The Signal 3G's compact form factor makes it an ideal component for M2M installations in weak signal environments. The Signal 3G can be paired with a variety of expertly designed Wilson Electronics cellular antennas for maximum system gain to overcome a weak signal. The Signal 3G is FCC certified to the latest technical standards for cell signal boosters. Availability of the Signal 3G allows OEMs to source a compact, powerful and highly compatible signal booster that is ready to deploy. Integrators can more easily custom design M2M communication systems that fit tightly constrained spaces.